Follow the next steps.

  Check if all the parts are available.

       Start to look for a suitable place on the floor for the water container ( 20 ltr. or 6.5 ltr. ), close to your terrarium.

       Fit the holder(s) into the glass or ventilation strip as follows (A), you will need a hole approximately 13 mm.

Connect the tube at one end to the 6 mm. fitting which is preinstalled at the pump, by pushing the tube firmly into the 6 mm. fitting (B). Now you have to measure the length of the tube from the pump towards the nozzle(s), and loose the swivelnut (C) of the holder.

       Cut the tube with a sharp knife ( to guarantee roundness ), and bring the tube into your terrarium by putting the tube through the holder for at least 3-5 cm (D).

       Connect the nozzle by pushing the tube firmly into the 6 mm. fitting (E). In case of dismounting, push back the ring of the fitting, and pull out the tube (F).

       When using 2 or more nozzles, you have to connect a divider on top of your terrarium (G). After this installation, pull back the tube a few centimetres and tighten the swivel nut (H) of the holder.  

       After the container is filled with ( clean ) water, the system will be ready for the first run.

       It can be useful to bleed the system first, by running the pump without connected nozzles

       Let the pump running until the water flows out of the tube, then shut of the pump, and reconnect the nozzle(s). Now all the air will be out of the system, and the nozzles will spray immediately. This action is just needed once, or every time the system was running dry, and air slipped into the system.

       But take care !, avoid a pump burn-out, never let the pump running dry. Be sure there is enough water in the container every time.

   Good luck !